Laser 7254 Hose Clamp Set 2pc, Black

They work really well. Nice and small little units that simply do the job. Really can't complain at all! 👌

Really good little clamps, impressed with them.

I was expecting something a bit more substantial, and had my doubts when they arrived.Clamped off brake lines just fine - although I used a pair of pliers to get a bit of leverage on the wing nuts.Had intended to replace the wing nuts with hex nuts so that I could use a spanner, but the thread isn't standard metric sizing

A must have in any mechanics tool box.

👍

I should have bought some hose clamps years ago. Quite cheap and does the job. Saved hours of brake bleeding on my motorcycle. A little difficult to fit on the rear hoses, but there wasn't much room anyway!

Perfect little tool to clamp the brake pipes

Laser products can usually be good but this basic item is to basic, merely an L shaped block of metal with hole drilled to fit a 90 degree bent bar with screw thread through, a small wing nut attached to tighten the bar.These purchased as being small one thought they would fit into confined spaces, however when fitted to a 15mm hose the wing nut to small to tighten enough to compress the hose sufficiently to stop the flow of fluid, to much tightening resulted in the thin 8mm bar digging into the hose misshaping the hose.These clamps may work on small diameter hose with a narrow bore but for bigger bore hoses they are difficult to use, to small to get sufficient purchase on the wing nut to tighten, thicker walled hoses requiring more force than can be applied by fingers.Unfortunately their restricted usage has left them relegated to a draw as not my first choice as a hose clamp.