NTE Electronics 54-645-B Round Hole Illuminated Rocker Switch, Square Bezel, SPST Circuit, ON-None-Off Action, Nylon Blue LED Actuator, 0.187" Quick Connect Terminals, 20A, 12V,Black

So far so good, nice positive detent, light is bright enough but not too bright. Used it on an AirLift air bag gauge because the AirLift gauge's backlight is annoyingly bright at night, and just doesn't need to be on at all times.

I used this switch to control trailer lights on my utility trailer. Whenever the lights were plugged into the wiring harness they would be on no matter if the parking lights were on or not. Checked for ground issues and other suggestions, but found it is just the way the controller for the lights works. Put this switch in so I could just turn the lights on manually and not worry about draining the battery. Works like a charm. LED is bright but not obnoxious.

The media could not be loaded.  Its a very well made quality, i was having issues finding the correct amperage on a switch, as with all after market projects, i had some trouble. This is a very good product and much cheeper than competitors in store's. That while they work aren't high enough quality to illuminate the led. Long story short i bought 2 extra if they ever break or if i add more lights later. 🤔 my only complaint is the led is a tad bright, but they do offer other colors to choose from.

I used it to switch a 12 volt battery box with USB ports, to recharge our cell phones during a power outage. 12 volt power in (positive from the battery) goes to terminal 1, the outside silver terminal. 12 volt power out (positive) to the accessory, load, fuse block or bus goes to terminal 2, the center silver terminal. Ground(negative) goes to terminal 3, the outside brass terminal. Connecting terminal 3 to ground allows the blue “power on” LED to illuminate. You don’t have to connect terminal 3 to ground if you don’t want the “power on” LED to illuminate. For example, my USB ports illuminate when power is applied, so I can use that illumination as my power on indicator, and not connect terminal 3 to ground. If you find the blue light annoying, don’t connect terminal 3 to ground. All your loads and accessories will be grounded directly back to the battery negative and don’t need to be connected to the switch ground.

Works great on LED bar light. The blue pilot light is a little bright. It's a nice quality switch.

Exceeded my expectations and would recommend this product to anyone needing a switch.

have ordered several of these,, most have worked well but others light up when turned off,,,, and others let as muvch as 6 volts pass thru when in off position,,,,,, all in all ok product

Works well. Make sure you wire it correctly. If you want the LED to work you need to connect to neutral. Switch feels solid.

Just as posted.